Purpose: The Cisco Solutions Implementation and Administration (CCNA) v1.0 course provides you with a broad range of fundamental knowledge for all IT careers. Through a combination of lectures and hands-on labs, you’ll learn how to install, operate, configure, and verify basic IPv4 and IPv6 networks.

---

Goals: The course covers the configuration of network components such as switches, routers, and wireless LAN controllers; network device management; and identify basic security threats. The course also gives you a foundation in network programmability, automation, and software-defined networking. This course helps you prepare to take the 200-301 Cisco® Certified Network Associate (CCNA) exam. By passing this exam, you earn the CCNA certification.

---

Addressed to: This course is designed for anyone seeking CCNA certification. The course also provides basic knowledge for all support technicians involved in the basic installation, operation, and verification of Cisco networks. Job roles best suited for the material in this course are: Entry-level Network Engineer Network Administrator Network Support Technician Computer Help Desk Technician

---

Previous requirements: Before taking this course, you should have: · Basic computer literacy. · Basic PC operating system navigation skills. · Basic internet usage skills. · Basic knowledge of IP address. There are no prerequisites for achieving the new CCNA certification, but you should make sure you have a good understanding of the topics covered on the exam.

Introduction to the Cisco Command Line Interface (CLI)
Watch how a switch works
Perform basic switch configuration
Deploy initial switch configuration
Inspect TCP/IP applications
Configuring an interface on a Cisco router
Configure and verify Layer 2 discovery protocols
Deploy an initial router configuration
Set default gateway
Explore packet forwarding
Troubleshoot Switch Media and Ports
Troubleshoot port duplex
Configure basic IPv6 connectivity
Configure and verify IPv4 static routes
Configure IPv6 static routes
Implement IPv4 static routing
Implement IPv6 static routing
Configure VLAN and Trunk
Troubleshoot VLANs and trunks
Set up a router on a stick
Implement multiple VLANs and basic routing between VLANs
Configure and Verify Single Area OSPF
Configure and verify EtherChannel
Enhance Redundant Switched Topologies with EtherChannel
Configure and verify IPv4 ACLs
Implement numbered and named IPv4 ACLs
Configure a provider-assigned IPv4 address
Configure static NAT
Configure Dynamic NAT and Port Address Translation (PAT)
implement PAT
Log in to the WLC
Monitor WLC
Configuring a dynamic interface (VLAN)
Configure a DHCP scope
Set up a WLAN
Define a Remote Access Dial-Up User Service (RADIUS) server
Explore management options
Explore the Cisco DNA™ Center
Configure and verify NTP
Configuring the system message log
Create the Cisco IOS Image Backup
Upgrade the Cisco IOS image
Configure WLAN using Wi-Fi Protected Access Pre-Shared Key (PSK) 2
(WPA2) via GUI
Secure console and remote access
Enable and limit remote access connectivity
Secure administrative access to the device
Configure and verify port security
Implement device hardening